Elation 15R Specifications download pdf (Page 22)

Platinum Beam 15R™

©Elation Professional® Los Angeles Ca. 90040 www.ElationLighting.com

You can set the same starting address for all fixtures or a group of fixtures, or set different

address for each individual fixture. Be advised that setting all you fixtures to the same

DMX address will subsequently control all fixtures in the same fashion, in other words,

changing the settings of one channel will affect all the fixtures simultaneously.

If you set each fixture to a different DMX address, each unit will start to “listen” to the

channel number you have set, based on the quantity of control channels (DMX channels)

of each fixture. That means changing the settings of one channel will only affect the

selected fixture.

In the case of the Platinum Beam 15R™, which is a 16 channel fixture (default), you

should set the starting DMX address of the first unit to 1, the second unit to 17 (16 + 1),

the third unit to 23 (16 + 17), and so on.

Note: During start-up the Platinum Beam 15R™ will automatically detect whether a DMX

data signal is being received or not. If DMX data signal is being received, the display will

show "Address XXX" (XXX representing the actual DMX address). If the fixture is not

receiving a DMX signal the display will flash. If your fixture is connected to a DMX

controller and the display is flashing (not receiving a DMX signal), please check the

following:

- The 3-PIN or 5-PIN XLR input plug (cable with DMX signal from controller) is not

connected or is not inserted completely into the DMX input jack of the fixture.

- The DMX controller is switched off or defective.

- The DMX cable or connector is defective.

- A DMX terminator has been inserted into the last fixture in your DMX chain.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 57 58

No comments

Elation 15R Specifications Page 22