Elation 15R Specifications download pdf (Page 20)

Platinum Beam 15R™

©Elation Professional® Los Angeles Ca. 90040 www.ElationLighting.com

Be sure to follow the above figure when making your own cables. Do not use the ground

lug on the XLR connector. Do not connect the cable’s shield conductor to the ground lug

or allow the shield conductor to come in contact with the XLR’s outer casing. Grounding

the shield could cause a short circuit and erratic behavior.

DMX-512 control connection

Connect the provided XLR cable to the female 3-pin XLR output of your controller and the

other side to the male 3-pin XLR input of the moving head (Please refer to the diagram

below.). You can chain multiple moving heads together through serial linking. The cable

that should be used is two conductor, shielded DMX cable with XLR input and output

connectors. Always be sure daisy chain your in and out data connections, never split or

“Y” your DMX connections unless you are using an approved DMX splitter such as the

Elation Opto Branch 4™ or DMX Branch/4™.

DMX-512 connection with DMX terminator

A DMX terminator should be used in all DMX lines especially in longer runs. The use of a

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 57 58

No comments

Elation 15R Specifications Page 20