Dr. DMX II USER'S MANUAL Web site: www.elationlighting .com E-mail: [email protected]
9 The Speed can will only take effect when the mode is set to Auto On/Off or Ramping. In this case, the level of the desired channel is adju
10 The default start cue is cue 1. You can adjust the end cue No. and speed rate ( 1 -10 ) by using multi-selector wheel. For more in
11 fig.1 fig.2 fig.3 fig.4 If you would like to set the lighting func
12 _ Save Cue ( Scene ) If there is DMX input signal present, the saved cue can be the received signal. However, if there is no signal inpu
13Otherwise, if the cable does not work normally, the LCD window displays: _ MIDI data -- RX This option tests the MIDI data to find out whether
14 operator, the channel value of the unit will change instantly, adjusting with the position of the fader. In the Hold display mode, when cha
15 You can also change the value display in three modes, including decimal, hexadecimal and percent. To save what you have set, move the cur
1_General Information Introduction Thank you for purchasing the Dr. DMXII. The Dr. DMXII features stylish design, versatility and a highly compet
2_Operation GuideDr. DMXII, which can be used in various lighting occasions to meet your requirements. This unitprovides ample menu options in a 20 x
3 If there is no signal input and you have accessed each menu of Data format, Data timing, Data level (Volt)by the multi-selector wheel, the LCD wind
4 (Here the connected controller is a DMX Operator.)Select “>” first and then press the multi-selector this will allow you to shift from the
5 This DMX data--RX function can display the value of the signal input by the means of a Barchart, Value, or Min/max, complying with the display
6 2. Value display This option can display the value of the signal input by the means of decimal, hexadecimal and percent. Turn the mul
7 Supposed that you have set the percent display mode. If there is no signal input, the LCD window will display. On the contrary, if th
8 To adjust the temporary value of the desired channel, first turn the multi-selector wheel to “>” at the third line. Then adjust the "
Comments to this Manuals